Wednesday, June 21, 2017

Crawfish Trap Pt2.

Crawfish Trap Pt2..

To get that ‘cone’ shape, I pulled one end over the other…

…and kept pulling, making it tighter


I then slid the cone into the end of the cylinder, making sure the cone tip poked in about 3 inches

After making sure the cone was at the desired shape, I secured it with zip ties

…and trimed off the zip tie ends

The tip of the cone was then cut off, leaving a hole that was about 2 1/2 inches in diameter

You guessed it, zippy ties were used to secure the cone into the end of the cylinder

.and yes, I trimmed those zippy ends!!!

To finish this end off, the excess wire was trimmed away from the bottom of the cone

No comments:

Post a Comment